HP P4459A Attach the Switch Rails to the Switch Chassis, Securing the Switch Rails to the Switch

HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide

Step 5: Attach the Switch Rails to the Switch Chassis

1.Remove the two side screws (one on each side of the switch chassis) that retain the cover, as shown in Figure 13. You will not use these short screws in the rest of this assembly.

Figure 13: Securing the Switch Rails to the Switch

Insert #1 Phillips-head screw provided

Switch Rails

Remove short screw here, and insert #1 Phillips-head screw provided

Switch

Insert #1 Phillips-

head screw provided

Rear Panel

Switch Rail Flanges

Remove short screw here, and insert #1 Phillips-head screw provided

2.Attach one of the switch rails to the side of the switch chassis with two of the #1 Phillips-head screws provided, as follows:

•Orient one switch rail against the switch chassis as shown in Figure 13. The flange on the switch rail is on the outer side of the switch rail and near the rear panel.

•Align the holes in the switch rail with the screw holes in the switch chassis as indicated in Figure 13.

•Insert the two #1 Phillips-head screws through the switch rail and into the switch chassis as shown in Figure 13. Tighten the screws.

3.Attach the second switch rail to the other side of the switch in the same way.

24