Installing the Fibre Loop Switch
Step 6: Install the switch
Have the remaining four Torx screws available as you install the switch.
1.Pick up the switch chassis (with the switch rails installed) with the open switch rail ends away from you. Carry it to the rear of the rack.
2.Carefully align the switch rail ends with the open rack sleeves, and gently ease the chassis into the rack sleeves like a drawer, as shown in Figure 14 and Figure 15.
3.Align the two holes on one switch rail with the holes with the barrel nuts on the rear rack column, as shown in Figure 14 and Figure 15.
4.Attach that switch rail to the rear rack column with two Torx screws. The screws go through the flange on the switch rail first, and then into the barrel nut. Finger tighten the screws.
25
