Install the battery
1. Open the Battery/Memory Card door by sliding the door latch as indicated on the Battery/Memory Card door.
2. Insert the battery in the larger slot, pushing the battery in until the latch catches.
3. Close the Battery/Memory Card door.
To remove the battery, press the battery latch as shown until the battery springs free.
Note Fully charge the battery before using it the first time (see Charge the battery
on page 7). Turn off the camera before removing the battery.
Charge the battery
To charge the battery in the camera:
1.Plug the small end of the USB cable into the
camera and the large end into the power adapter, then plug the power adapter into an electrical outlet, as shown. The camera's blinking Battery Charging light indicates that the battery is charging. The battery
is fully charged when the Battery Charging light
turns on solid (see Recharging the Lithium Ion battery on page 49 for information on charging times).
2.When charging is complete, disconnect the camera from the power adapter.
Note For other methods for recharging the battery, see Recharging the Lithium Ion battery on page 49.
Turn on the camera
To turn on the camera, slide the lens cover open until it clicks, uncovering the lens.
To turn off the camera, slide the lens cover closed until it clicks, covering the lens.
Caution When sliding the lens cover, keep your fingers clear of the lens. Fingerprints on the lens can impair the quality of the picture.
HP Photosmart R837 Digital Camera | 7 |
