HP rp5000 Base Model Point of Sale manual Defining LED Indicators, Standard Beeper Definitions

	Operating the Scanner
Standard Beeper Definitions
Beeper Sequence	Indication
Code 39 Buffering
Hi/lo beep	New Code 39 data was entered
	into the buffer.
3 Beeps - long high beep	Code 39 buffer is full.
Lo/hi/lo beep	The Code 39 buffer was erased or
	there was an attempt to clear or
	transmit an empty buffer.
Lo/hi beep	A successful transmission of buffered
	data.
4 short high beeps	Scanner has not completed
	initialization. Wait several seconds
	and scan again.

Scanner gives a power-up beep after scanning a USB Device Type

Communication with the bus must be established before the scanner can operate at the highest power level.

The power-up beep occurs more than once

The USB bus may put the scanner in a state where power to the scanner is cycled on and off more than once. This is normal and usually happens when the PC cold boots.

Defining LED Indicators

In addition to beeper sequences, the scanner communicates using

atwo-color LED display. Refer to the “Standard LED Definitions” table in this chapter to define the LED colors that display during scanning.

User Guide www.hp.com 4–3