Before You Begin

Observe the following requirements before removing and replacing the component:

IMPORTANT: Due to the small computer size, you can only install a small, low-profile PCI card of the same approximate size of the modem card. HP recommends that you install a card with power consumption of 5 watts or less.

Not all low-profile cards will fit into the PCI slot. Some external connectors, especially connectors located at the top of the card, may not fit properly into the back panel.

IMPORTANT: Due to the small computer size, you can only install a small, low-profile PCI-E card of the same approximate size of the graphics card. HP recommends that you install a card with power consumption of 25 watts or less.

Not all low-profile cards will fit into the PCI-E slot. Some external connectors, especially connectors located at the top of the card, may not fit properly into the back panel.

This procedure requires a Phillips screwdriver.

Removing a PCI Card

1 Prepare the computer and remove the computer cover. Complete the procedures “Opening the Computer” on page 2.

2 Inside the computer, locate the PCI card slot on the motherboard.

3 Make a note of any internal cables attached to the card, and then disconnect them.

4 Remove the screw on the modem card bracket holder on the outside of the frame. Remove the bracket holder.

5 Hold the card at the top, and carefully pull the card straight out of the slot.

20Upgrading and Servicing Guide