Configuring VLANs Using SAM

Configuring VLANs Using SAM

Configuring VLANs Using SAM

You can use SAM to configure VLANs by completing the following steps:

1.Log in as root.

2.Check the HP-UX version by typing: uname -a. The version should be HP-UX 11i (11.11)

3.At the HP-UX prompt, type: sam

4.At the SAM main window, double click:

Networking and Communications

5.There are then 2 ways to access VLAN configuration. Either choose the icon Virtual LAN, or choose Network Interface Cards and then show the VLANs by using the List Pulldown.

SAM displays a list of VLAN-aware physical interfaces and all VLANs created on them (Figure 3-1).

Figure 3-1 List Pulldown with Virtual LANs Displayed

38

Chapter 3

Page 38
Image 38
HP T1453-90001 manual Configuring VLANs Using SAM, List Pulldown with Virtual LANs Displayed