HP UX Developer Tools QuickStart Install Instructions

ClusterPack V2.5 Release Note

QuickStart Install Instructions

If you have installed ClusterPack before, follow the instructions in this section as a quick reminder. Refer to “Comprehensive Install Instructions” on page 13 for detailed instructions.

If you have not installed ClusterPack before, use the Comprehensive Install Instructions section instead. This QuickStart Guide does NOT cover the use of Golden Images. If you wish to use Golden Images, use the Comprehensive Install Instructions section instead.

IMPORTANT If you perform these steps out of order or omit steps, your installation will leave your systems in an unknown and non-deterministic state.

Step 1. Fill Out the ClusterPack Installation Worksheet

To help you collect the information needed for the installation, you may print a worksheet from <DVD mount point>/CPACK-HELP/Tutorials/opt/clusterpack/ share/help/ohs/docs/cpack_worksheet.pdf. Fill out all the information for each node in your cluster.

NOTE	You will not be able to complete the following steps if you have not
	collected all of this information.

Step 2. Install Prerequisites

The installation prerequisites for ClusterPack are important. You should read and understand all the prerequisites for ClusterPack installation before beginning the cluster setup.

ClusterPack v2.5 can be used with either HP-UX 11iv2 or HP-UX 11iv3. The version of the operating system on the cluster must be the same for the management server, and all the Compute Nodes.

For HP-UX 11iv2

Install the following software on the Management Server.

•HP-UX 11iv2 TCOE

•HP-UX 11i Ignite-UX (B5725AA)

Install the following software on each Compute Node.