Populating DIMM Sockets

There are four DIMM sockets on the system board, with two sockets per channel. The sockets are labeled DIMM1, DIMM2, DIMM3, and DIMM4. Sockets DIMM1 and DIMM2 operate in memory channel A. Sockets DIMM3 and DIMM4 operate in memory channel B.

Figure 2-8DIMM Socket Locations

Table 2-1DIMM Socket Locations

Item

Description

Socket Color

 

 

 

1

DIMM1 socket, Channel A (populate first)

Black

 

 

 

2

DIMM2 socket, Channel A (populate third)

White

 

 

 

3

DIMM3 socket, Channel B (populate second)

White

 

 

 

4

DIMM4 socket, Channel B (populate fourth)

White

NOTE: A DIMM must occupy the black DIMM1 socket. Otherwise, the system will display a POST error message indicating that a memory module must be installed in the wrong socket.

The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending on how the DIMMs are installed.

The system will operate in single channel mode if the DIMM sockets are populated in one channel only.

The system will operate in a higher-performing dual channel mode if the total memory capacity of the DIMMs in Channel A is equal to the total memory capacity of the DIMMs in Channel B. The technology and device width can vary between the channels. For example, if Channel A is populated with two 1-GB DIMMs and Channel B is populated with one 2-GB DIMM, the system will operate in dual channel mode.

The system will operate in flex mode if the total memory capacity of the DIMMs in Channel A is not equal to the total memory capacity of the DIMMs in Channel B. In flex mode, the channel populated with the least amount of memory describes the total amount of memory assigned to dual channel

18 Chapter 2 Hardware Upgrades

ENWW

Page 24
Image 24
HP VS803UT manual Populating Dimm Sockets, 1DIMM Socket Locations