HP VS803UT manual Installing and Removing Drives, 19Extra Guide Screw Locations

Installing and Removing Drives

When installing additional drives, follow these guidelines:

●The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on the system board labeled SATA0.

●Connect a SATA optical drive to the white SATA connector on the system board labeled SATA1.

●Connect devices in order of SATA0, SATA1, then SATA2

●Connect an optional eSATA adapter cable to the black ESATA connector on the system board.

●Connect a media card reader USB cable to the USB connector on the system board labeled MEDIA. If the media card reader has a 1394 port, connect the 1394 cable to the 1394 PCI card.

●The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.

●You must install guide screws to ensure the drive will line up correctly in the drive cage and lock in place. HP has provided extra guide screws for the external drive bays (five 6-32 standard screws and four M3 metric screws), installed in the front of the chassis, under the front bezel. The 6-32 standard screws are required for a secondary hard drive. All other drives (except the primary hard drive) use M3 metric screws. The HP-supplied metric screws are black and the HP-supplied standard screws are silver. If you are replacing the primary hard drive, you must remove the four silver and blue 6-32 isolation mounting guide screws from the old hard drive and install them in the new hard drive.

Figure 2-19Extra Guide Screw Locations

No.	Guide Screw	Device
1	Black M3 Metric Screws	All Drives (except hard drives)
2	Silver 6-32 Standard Screws	Secondary Hard Drive

There are at total of five extra silver 6-32 standard screws. Four are used as guide screws for a secondary hard drive. The fifth is used for bezel security (see Front Bezel Security on page 55 for more information).

ENWW Installing and Removing Drives 29