HP 9300, XZ837UT manual Installing Memory, DDR3-SDRAM SODIMMs

3.Loosen the captive screw (1) and slide the security cover out of the center cavity (2). Figure 2-6Removing the Rear Port Security Cover

Installing Memory

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3- SDRAM) small outline dual inline memory modules (SODIMMs).

DDR3-SDRAM SODIMMs

For proper system operation, the SODIMMs must be:

●industry-standard 204-pin

●unbuffered non-ECC PC3-10600 DDR3-1333 MHz-compliant

●1.5 volt DDR3-SDRAM SODIMMs

The DDR3-SDRAM SODIMMs must also:

●support CAS latency 9 DDR3 1333 MHz (9-9-9 timing)

●contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification In addition, the computer supports:

●512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies

●single-sided and double-sided SODIMMs

●SODIMMs constructed with x8 and x16 devices; SODIMMs constructed with x4 SDRAM are not supported

NOTE: The system will not operate properly if you install unsupported SODIMMs.

ENWW Installing Memory 13