User Manual
Aolynk DR814Q ADSL2+ Broadband Router 5 Advanced Configuration
47
Table 5-4 Description of trigger setting items
Item Description
Transport Type Transport type of the trigger port. From the drop-down list,
select a transport type (TCP or UDP) to which the newly added
trigger is specified.
Port Range Port range of the trigger port. (1 – 65535)
Triggered Port
Range Port range of the triggered port. (1024 – 65535)
5.2.4 NAT
The NAT technology can translate the internal private address of a PC in the LAN into a
valid public IP address, and thus the PC can communicate with the WAN. Click the
[NAT] tab of the security setup page to enter the corresponding page shown in Figure
5-11.
Figure 5-11 NAT settings

I. Configure NAT

Before configure NAT, select a service interface from the [IP Interface] drop-down list so
that NAT and static NAT run on this interface.
Select the Enable/Disable option behind “NAT” to enable/disable NAT.

II. Configure static NAT

The [Static NAT] section is used to configure NAT conversion items. Public IP
addresses correspond to private IP addresses in a one-by-one way.