5. Assemble the Portable Case
In this procedure, you will install the base assembly into the portable case.
1.Unzip the largest opening on the front of the portable case.
2.Insert the base assembly into the portable case, so that the PiranhaMAX control head is facing out of the case. For best results, pull the case over one shoulder of the handle at a time.
3.Adjust the case so that you can easily grab the handle, through the fabric handhold inset, from the outside top of the portable case.
Installing the Base into the Case | Pulling the Case over the Handle | Holding the Portable Case |
Figure 38
6. Charge and Install the Battery
In this procedure you will charge and then install and secure the battery.
1.Charge the battery, using the included battery charger, until it is fully charged as indicated by the LED on the charger. Charging usually requires 8 continuous hours but may vary depending on your configuration.
NOTE: Some international models may not include a battery or battery charger.
2.Open the bottom back zipper on the portable case, and install the battery in the battery well. While holding the
Installing the Battery).
27PiranhaMAX Portable Case Assembly