4.Install the handle onto the base, so that the curved part of the handle faces towards the back of the base, towards the battery well. Use the four included #8-32 x 7/16" screws, two on each side, to attach the handle to the base (see the illustrations Installingthe Handle Onto the Base and Sliding in the Handle). Hand tighten only!

Installing the Handle Onto the Base

Sliding in the Handle

Figure 31

NOTE: The handle is keyed so that it only fits onto the base in one direction.

3. Attach the Control Head to the Base and Handle

In this procedure you will install the control head onto the base assembly.

1.Insert the thumbknob bolt through the pivot knuckle on the control head.

2.Align the pivot knuckle with the mount arms and slide into place, twisting slightly if necessary, until the unit is firmly seated.

3.Rotate the control head to the desired angle and hand tighten the thumbknob bolt.

4.Thread the gimbal knob onto the pivot bolt and tighten.

23PiranhaMAX Portable Case Assembly