6.Fit the transducer jumper cable connector down into the jumper cable well and snap it into place. Insert the two
7.Secure all cables to the base, using the included zip ties, at the mount points shown in the illustration (see the illustration Tying Down the Cables).
| Tying Down the Cables |
Zip Tie | Transducer |
Mounting | Jumper Cable |
Point |
|
Power Cable
Figure 37
8.Turn the base right side up and pull up gently on the battery
NOTE: You will need to perform more assembly procedures, as well as charge the battery for 8 hours, before you install the battery into the portable case. See Charge and Install the Battery for more information.
PiranhaMAX Portable Case Assembly | 26 |