Inserting the Pivot Bolt 3. Put the pivot bolt through the assembly to hold it in position and loosely install the nut, but do NOT tighten the nut at this time (Figure 19).

CAUTION! Do not use a high speed driver on this combination of fasteners. Hand tighten only.

Figure 19

Mounting the Assembly

to the Transom

Figure 20

4.Align the mounting bracket transducer assembly with the drilled holes in the transom. With a 5/16" socket driver, mount the assembly to the transom using the two #10 - 1" long screws provided (Figure 20). Hand tighten only!

NOTE: Make sure that the mounting screws are snug, but do not fully tighten the mounting screws at this time to allow the transducer assembly to slide for adjustment purposes.

5.Adjust the initial angle of the transducer from back to front by rotating the transducer until the side seam on the transducer is almost parallel with the bottom of the boat, one click at a time in either direction (Figure 21 and 22).

Adjusting the Initial Transducer Angle

One click too high

Correctly aligned (transducer side seam aligned with boat bottom)

Trailing edge

Leading edge One click too low

Figure 21

Figure 22

Transom Transducer Installation

14