3. Assemble the Control Head Base
Your control head base will have a tilt and swivel mount. See the instructions below to assemble and mount the control head base.
Tilt and Swivel Mount
Control Head Base Assembly
Mount Arms
Base
Swivel
Ring
Countersink
Side Out
Arm Screws, 4 #6 x7/16"
Figure 5
To assemble a tilt and swivel mount:
1.Insert the mount arms into the base. Then, hold the mount arms in place as you turn the base upside down.
2.Insert the swivel ring into the base, with the countersink holes for the arm screws facing out.
3.Secure the mount arms with the four #6 screws provided (Figure 5). Hand tighten only!
4.Set the assembled control head base in place on the mounting surface. Mark the four mounting screw locations with a pencil or punch.
5.Set the base aside, and drill the four mounting screw holes using a 9/64" bit.
6.Proceed to Route the Control Head Cables Under the Deck.
Fixed Control Head Installation | 4 |