Table of Contents |
|
Accessory Bus | 29 |
Powering Up the Unit | 29 |
The Menu System | 30 |
32 | |
Normal Operation | 32 |
Simulator | 33 |
System Status | 34 |
PC Connect (with PC Connect Cable Only) | 35 |
Sonar | 36 |
Side View (WideSide® Transducer: WideSide® View Only) | 37 |
Sensitivity | 37 |
Upper Range (Advanced: Sonar, Split Sonar and Big Digits Views Only) | 38 |
Lower Range | 38 |
Side Beam Range (WideSide® Transducer: WideSide® View Only) | 39 |
Chart Speed | 39 |
Bottom View | 40 |
Navigation | 41 |
Save Current Track | 42 |
Clear Current Track | 42 |
Save Current Route (Only When Navigating) | 42 |
Skip Next Waypoint (Only When Navigating) | 43 |
Cancel Navigation (Only When Navigating) | 43 |
Remove Target (Only If a Target is Active) | 43 |
Remove Grid (Only If a Grid is Active) | 44 |
Sonar Window (Combo View Only) | 44 |
Sonar Menu Tab | 45 |
Beam Select | 46 |
Fish ID+™ | 47 |
Fish Sensitivity | 48 |
Real Time Sonar (RTS®) Window | 48 |
83 kHz Sensitivity (Advanced) | 48 |
455 kHz Balance (Advanced: with QuadraBeam™ Transducer) | 49 |
WideSide® Sensitivity (Advanced: With WideSide® Transducer) | 49 |
Depth Lines (Advanced) | 50 |
Surface Clutter (Advanced) | 51 |
Noise Filter (Advanced) | 51 |
Max Depth (Advanced) | 52 |
Water Type (Advanced) | 52 |
Transducer Select | 52 |
Table of Contents |
|
Navigation Menu Tab | 53 |
Tracks | 54 |
Waypoints | 54 |
Routes | 55 |
View Orientation | 55 |
Chart Detail Level | 56 |
Map Borders | 56 |
Lat/Lon Grid | 57 |
Spot Soundings | 57 |
Shaded Depth | 57 |
North Reference | 57 |
Grid Rotation | 58 |
Trackpoint Interval | 58 |
Track Min Distance (Advanced) | 58 |
Map Datum (Advanced) | 59 |
Set Simulation Position (Advanced) | 59 |
Set Map Offset (Advanced) | 59 |
Clear Map Offset (Advanced) | 60 |
Delete All Nav Data (Advanced) | 60 |
Alarms Menu Tab | 61 |
Depth Alarm | 62 |
Fish ID Alarm | 62 |
Low Battery Alarm | 62 |
Temp Alarm | 63 |
Off Course Alarm | 63 |
Arrival Alarm | 64 |
Drift Alarm | 64 |
Alarm Tone | 65 |
Setup Menu Tab | 66 |
Units - Depth | 67 |
Units - Temp (International Only) | 67 |
Units - Distance | 67 |
Units - Speed | 68 |
User Mode | 68 |
Language (International Only) | 68 |
Triplog Reset | 69 |
Restore Defaults | 69 |
Select Readouts (Advanced, Sonar View Only) | 70 |
Depth Offset (Advanced) | 71 |
Temp Offset (Advanced) | 71 |
Speed Calibration (Advanced, with Temp/Speed Only) | 71 |
Local Time Zone (Advanced) | 72 |
iii | iv |
