Husqvarna 343R, 345RX, 343F, 345FX, 345FXT manual Replacing the spark, plug cover, 502 50, 502 51

2	Electrical system
	Still no spark?	Still no spark?
	Check the air gap.	Check the air gap between the flywheel
		magnet and the ignition module. The
		gap should be 0.3 mm.
		Use a 502 51 34-02 feeler gauge.
	0.3
	502 51 34-02
	Adjust the air gap.	Adjust the air gap as needed to the
		correct value.
		•	Loosen the bolts.
		• Position the feeler gauge and press
			the ignition module against the
			flywheel.
		• Tighten the bolts and check the air
			gap again.
		If the spark plug still does not fire, the
		ignition system should be replaced.

Replacing the spark	Replacing the spark
plug cover	plug cover
1. Insert the ignition cable through the	1. Lubricate the ignition cable with a
spark plug cover.	little grease and thread it through
2. Make a hole in the ignition cable for	the spark plug cover.
the ignition coil.	2. Cut off a bit of the ignition cable
	(approx. 5 mm) and make a hole in
	the cable for the ignition coil with
	the aid of a pair of no. 502 50 06-01
	pliers.

502 50 06-01
3. Attach the ignition coil to the ignition	3.	Attach the ignition coil to the ignition
cable.		cable and ensure that the wire is
		folded along the cable.
	4.	Pull the ignition coil into the spark
		plug cover.

NOTE!

It is important that the tip of the ignition coil hits the centre of the ignition cable to prevent sparking.

10