Husqvarna 343R, 345RX, 343F, 345FX, 345FXT manual Wiring diagram, Electrical system

Electrical system 2

Separate the contacts (A-A) and (B-B).

Then extend the cables (A) and (B) with approx. 90 cm long steel wires attached to the contacts.

Remove the bolt and pull off the left grip from the handle.

Pull one cable at a time from the handle.

Remove the heating element from the handle with a pair of flat nosed pliers.

Separate the contacts (A-A) and (B-B).

Then extend the cables (A) and (B) with approx. 90 cm long steel wires attached to the contacts.

This is to make it easier to draw the cables to the new heating element back through the handle.

1 = black

2 = blue

Remove the bolt that holds the left grip on the handle.

Pull out handle from the handlebars and then the cables, carefully and one at a time, so that the steel wire does not loosen from the cables.

The heating element is located in a pocket in the outside of the handle.

Use flat nose pliers to pull out the heating element from the handle.

NOTE!

Do not pull the cables or their connections. Connections can be easily broken.

Assemble in the reverse order as set out for dismantling.

Wiring diagram

LH	=	Left handle
RH	=	Throttle
HC	=	Heater switch
TT	=	Triple contact
IM	=	Ignition module
SC	=	Short-circuit switch
Gen	=	Generator
Blu		= blue
Bl		= black
Re		= red
Bl/Blu		= black/blue

Use a universal tool when checking wiring and heating elements. Set the instrument to measure resistance to check for open circuits.

13