Husqvarna 343R, 345RX, 343F, 345FX, 345FXT manual Starter, Assembly

Starter	1
Remove the spring cassette.		Remove the two bolts holding the
		spring cassette and remove the
		cassette for replacement if necessary.

!WARNING!

Wear protective glasses. The return spring can fly out and cause personal injury if improperly handled.

Assembly

Clean requisite parts and assemble in the reverse order as set out for disman- tling.

Assembly

Clean all components before assembly:

Change return springs, starter pulley and starter cord as needed.

NOTE!

Be careful when opening the packaging with the return spring so that the spring does not fly out.

Attach the spring cassette. Attach the starter pulley. Attach the new starter cord.

Attach the spring cassette and tighten the two bolts (A).

Lubricate the bearing journal with a little grease and attach the starter pulley.

Place the washer in place and tighten the bolt.

Attach the new starter cord. Push it in to the starter pulley’s track as illustrated and then out through the cord guide in the starter cover. Make sure that the knot at the end of the cord is as small as possible!

NOTE!

New starter cords can be attached without dismantling the starter!

Anchor the cord in the starter handle.

Thread the cord through the starter handle and anchor it with a knot.

Fold down the free end and pull the knot well into the handle.

5