Husqvarna 80792 Fixed Line Trimmer Heads, Option 1-Single Line, Holder A, Option 2-Double Line

INSTALLATION INSTRUCTIONS

Fixed Line Trimmer Heads

Model View

The fixed line trimmer head is a tough aluminum die-cast trimmer head that is virtually impossible to break. It accepts line up to .130 in. diameter and will perform well in heavy-duty applications.

NOTE: The fixed line trimmer head will fit straight shaft grass trimmers ranging from the T18 through the B450. When installing the head onto a trimmer, pay special attention to the correct use assembly components as shown to the right (supplied with the trimmer head):

T18, T230/C230
Item	Part No.
Spacer	22035-13230
Holder A	22035-13242
Bolt Guard	22035-13290
Arbor Bolt	22035-13271
T250/C250, T260/C260
Item	Part No.
Holder A	22024-13912
Bolt Guard	22024-13291
Arbor Bolt	22000-13512
T270/C270

12

Trimmer	Option 1–Single Line
Gearcase

Spacer

(T18-T230)Fixed Line

Trimmer

Head

Holder A Option 2–Double Line

Washer

(270 only)

Bolt Guard

Arbor Bolt

Item	Part No.
Holder A	22420-13510
Flat Washer	99909-92810
Bolt Guard	22024-13291
Arbor Bolt	22000-13512
T350
Item	Part No.
Holder A	22000-13241
Bolt Guard	22015-13270
Arbor Bolt	22000-13512
C350, B450
Item	Part No.
Holder A	22015-13241
Flat Washer	99909-92810
Arbor Bolt	22015-13261

Replacement Line

Up to .130 in. diameter. Refer to the Shindaiwa Accessory Catalog for

If the machine (size ranging from T18 to T230) is already equipped with a trimmer head, unthread the existing trimmer head (clockwise to remove) and remove all adapters. Replace the spacer and install all the components shown here. Tighten the arbor bolt securely.

Cut either one or two 16-inch lengths of trimmer line (depending upon how much line you want exposed for trimming) and thread it through the trimmer head as shown.

CAUTION: Make sure the line is trimmed evenly to avoid vibration.

more information.

WARNING!

NEVER USE WIRE ROPE TRIM- MER LINE WITH A FIXED LINE TRIMMER HEAD.

3

Some applications may require that the line be trimmed to clear the cutting attachment shield, as shown.

25