INSTALLATION INSTRUCTIONS
E-Z Load and E-Z Pro Trimmer Heads
E-Z Load
E-Z Pro
NOTE: Operating with trimmer line of uneven length will cause excessive vibration. Always make sure the line is wound evenly and trimmed to equal lengths from the eyelets.
Fits LT18, T18, LT20, T20, C20, T230, C230, 22T
Fits F20, T25, C25, T250, C250, T27, C27, T270, C270, T260, C260, BP35
Fits T25, C25, T27, C27, T250, C250, T270, C270
Fits B40, B45, B450, C35, C350, RC45
Line Chart
Maximum fill–
45 feet of .080
34 feet of .095
32 feet of .105
Shipped with 15 feet of .095 line.
Maximum fill–
50 feet of .080
40 feet of .095
36 feet of .105
1 | 2 | 3 |
Press the upper body in at the spots marked “Push Open”. Pull the lower part of the trimmer head down.
Remove the line spool from the lower body of the trimmer.
If nylon line is extending through the eyelets, push the bump knob in while rotating the line spool until the slots in the spool line up with the eyelets, then remove the spool.
4 | 5 | 6 |
Clean and inspect the spool, housing and eyelets. Replace worn or dam- aged components.
Cut two equal lengths of trimmer line, no longer than 25 feet each. Place an end from each piece of line in the holes in the center of the spool.
While holding the line ends, pull each line down toward the inside of the spool through the slots next to the holes.
8
