SAFETY
Rollover Protection System (ROPS)
The ROPS increases the basic weight of the unit by 73 lbs/33 kg.
•Do not use the ROPS as a lifting, attaching or anchoring point.
•Do not use the ROPS for wrecking or towing.
•Do not exceed Max GVW: 2822 lbs/1283 kg.
•Securely fasten the seat belt if the unit has a ROPS.
•Where possible, avoid operating the unit near ditches, embankments and holes.
•Reduce speed when turning, crossing slopes and on rough, slick or muddy surfaces.
•Stay off slopes too steep for safe operation.
•Be aware of the mowing path, especially at row ends, on roads and around trees.
•Do not permit take passengers.
•Operate the mower smoothly, make no jerky turns, starts or stops.
•When the mower is stopped, set brakes securely and use the park brake.
•If any part of the ROPS is damaged, the entire ROPS must be replaced.
•Before each use, check for the correct torque on all bolts, including those on the seat belt.
•Check the ROPS structure for damage before each use.
•ROPS bar is NOT intended for use in sub zero temperatures.
WARNING!
The rollover protection system's capabilities may be impaired by damage if the mower is overturned or if alteration to the ROPS occurs. If these conditions take place, the total structure MUST be replaced.
WARNING!
This mower is equipped with an internal combustion engine and should not be used on or near any unimproved forested, bush covered or grassy lands unless the engine's system is equipped with a spark arrester meeting applicable local or state laws (if any).
WARNING!
The engine and the exhaust system become very hot during operation.
There is risk for burns if touched.
Allow engine and exhaust system to cool to a safe temperature before refueling.
Spark Arrestor
A spark arrester is standard equipment on the unit and is attached to the engine muffler. Clean the interior screen regularly, depending on usage and conditions.
The engine and the exhaust system become very hot during operation and there is risk for burns if touched.
Allow the exhaust system to cool to a safe temperature before cleaning the screen.
To clean, slide the spark arrestor screen out of the muffler. Clean the carbon from the screen with a soft brush or cloth.
Replace screen and reattach the tail pipe, orienting the tail pipe either horizontally or upwards, away from grassy surfaces.
Regularly clean spark arrestor screen
17
