INSTALLATION
Remeber the following with regard to the working area boundaries:
•The Auto Mower can mow areas with a gradient of up to 1: 3 (33 cm/m) inside the working area. Areas that slope more must be demarcated by the bound- ary wire. If any part of the working area’s outer edge has a gradient of 1: 5 (20 cm/m) or more, the wire should be laid inside where the slope starts. The Auto Mower may find it difficult to turn at the loop where the ground slopes heavily.
•Use the boundary wire to demarcate areas inside the working area, for example, flower beds and
fountains. Lay the cable up to the area, around it and then return along the same route. If staples are used, the cable should be laid under the same sta- ple on the return route.
Minimise
•Obstacles that can withstand a collision, for exam- ple, trees or bushes higher than 10 cm, do not need to be demarcated by the boundary wire. The Auto Mower will turn when it collides with this type of obstacle.
However, for the most gentle and silent operation, it is preferable to demarcatee all fixed objects in and around the working area.
•Obstacles that slope slightly, for example, stones or large trees with raised roots, should be demarcated
or removed. The Auto Mower can slide up onto this kind of obstacle causing the blades to be damaged.
Remember the following with regard to secondary areas and passages:
•If there are secondary areas close to the main area the boundary wire should be laid so that these areas form an ”island” outside of the main area.
Secondary areas are working areas without the charging station, but which are encircled by the same boundary wire as the main area. The Auto Mower must be moved manually between the main and secondary areas.
If the garden consists of two areas where one area is much smaller than the other and the areas are only connected by a very long narrow passage, it may be suitable to create a secondary area.
Secondary area |
Main area |
