| 5. Repair and adjustment | 5. Reparatur und Einstellung | ||
| 5. Réparations et réglages | 5. Herstellen en afstellen | ||
| 5. Riparazioni e messa a punto 5. Reparación y ajuste | |||
1. | Handle (low position) |
| Position handle | |
Loosen handle lock lever (fig. 16). Handle can be positioned | ||||
2. | Handle (high position) | |||
at different settings between "high" and "low" positions (fig. | ||||
3. | Handle lock lever | 16). Retighten handle lock lever. | ||
4. | Belt guide "B" | NOTE! | ||
5. | Belt guide "A" | Select handle height suitable for you and your tilling conditions. | ||
6. | Engine pulley | Handle height will change when tiller digs into the soil. | ||
|
| |||
7. | Idler pulley | WARNING! | ||
8. | Extention spring | |||
Stop the engine and remove the spark plug wire and cover | ||||
9. | Transmission pulley | |||
from the spark plug (fig. 7) before cleaning out the tines by | ||||
10. | Drive control cable | hand. Use caution - tines are sharp. | ||
11. | Cable clip screw |
|
| |
|
| IMPORTANT! | ||
|
| Place blocks under transmission to keep tiller from tipping. | ||
| FIGURE 16 |
| Ground drive belt adjustment | |
| 2 |
| ||
| For proper belt tension, the extension spring (fig. 17) should | |||
|
| |||
|
| have about 5/8 inch stretch with drive control bar in engaged | ||
|
| position (fig. 9). This tension can be obtained as follows. | ||
|
| a. Loosen cable clip screw securing the drive control cable | ||
|
|
| (fig. 17). | |
|
| b. | Slide cable forward for less tension and rearward for more | |
| 3 |
| tension until about 5/8 inch stretch is obtained. | |
| c. | Tighten cable clip screw securely. | ||
|
| |||
1
FIGURE 17 | 11 | 10 |
|
| |
4 | 5 |
|
6
7
9 8
46
