5
1. Belt guard
2.Screw
3.Nut
4.Hairpin clip and retaining pin
5.Hex nut (located behind tire)
6.New tine
7.Worn tine
8.Sharp edge
9.Hairpin clip
10.Retaining pin
Ground drive belt replacement
a.Remove hairpin clip and retaining pin (fig. 18) from hub of left hand wheel. Pull wheel out from tiller about
b.Remove belt guard by removing two (2) screws, one (1) hex nut and three (3) washers so that belt guard can slide straight out away from engine (fig. 18).
c.Loosen belt guides "A" and "B" (fig.
d.Remove old belt by slipping from idler pulley (fig. 17) first.
e.Place new belt in groove to transmission pulley (large pulley) and into groove of engine pulley (fig. 17). Belt must be in groove on top of idler pulley (fig. 17). Note positon of belt to guides.
f.Tighten belt guides "A" and "B" (fig. 17
Tine replacement
FIGURE 18
1 2
5
A badly worn tine causes your tiller to work harder and dig shallower. Most important, worn tines can not chop and shred organic matter as effectively nor bury it as deeply as good tines. A tine this worn (fig. 19) needs to be replaced.
To maintain the superb tilling performance fo this machine the tines should be checked for sharpness, wear and bending, particulary the tines which are next to the transmission (fig. 20). If the gap between the tines exceeds
New tines should be assembled as shown in figure 21. Sharp- ened tine edges will rotate rearward from above (fig. 21).
3 
4
FIGURE 19
67
FIGURE 20
Tine |
|
| max. |
IMPORTANT!
Never tamper with the engine governor, which is factory set for proper engine speed.
FIGURE 21
Counter tine
8rotation
9
10
52
