Assembly Instructions, Assembly delivery service | Husqvarna DT22

ASSEMBLY INSTRUCTIONS

Assembly – delivery service

1.Rotate the handle and tighten it in place.

2.Fill the engine with the manufacturer-recommended oil. See section ”Lubrication/Engine oil”.

3.Test the clutch. Make sure that the clutch expansion spring disengages easily.

4.The engine RPM is preset by the manufacturer. Idle speed is 1250–1400 RPM. Maximum engine speed is 3600 RPM.

See the engine manual for instructions on adjusting the regulator and carburetor if the engine speed is not within these limits.

1

3

4

2

DT03

1.Handle

2.Oil refill engine

3.Clutch cable

4.Clutch bail

40

Image 40

Husqvarna DT22 manual Assembly Instructions, Assembly delivery service

Contents

DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructions Location of decals Decal Seed application chart Translation of instructions Safety Instructions General use Safety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation Presentation Main components and operating instruments Engine Throttle control Starter Starter handleFuel valve Choke Spark plug MufflerOil dipstick Oil drainage Fuel tank Fueling Cutting unit Depth lever Depth knobDepth lock Clutch Setting blade height Blade versatilityFlail blade Delta blade Operation Starting the engine Cutting the engine Starting Before you startFinishing Maintenance Maintenance schedule Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Fitting the wrong spark plug type can damage the engine Checking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail blades Wear/Replacing delta blades Screws Delta BladeNuts Wear/Replacing spring tines Spring Tine Screw Cleaning and washing Two minute rule Lubrication schedule LubricationGeneral Engine oil Checking the engine’s oil level Depth knob with depth lock BladesDepth lever Handle Troubleshooting Symptom Cause Engine will not start Storage ServiceWinter storage Technical Data Specifications DT22 Assembly Instructions Assembly delivery service Bagger Assembly Assembly directions, catcher bag Attach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in place Re-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seeder Delivery service Service JournalAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10