BAGGER ASSEMBLY
22. Wire tie the cable to the handle. See Figure10.
DT17 |
FIGURE 10
23.Check adjustment of clutch cable. If cable needs adjusting, the adjusting should be done at the lower end with the spring.
Adjust as follows:
Pull the clutch bail tightly against the handle. The spring stretch should be 3/8" - 1/2".
If this range is not met, the adjustment should be done closest to the spring.
24. Replace belt cover.
WARNING!
DO NOT use or start the engine until the catcher bag is in place.
WARNING!
Machines equipped with a catcher MUST not be used with defective catcher bags or without the catcher bag in place.
They pose a risk of thrown stones, eye in- jury and inhalation of dust.
25.Fit catcher bag to the bag frame as follows:
•Affix the bag’s plastic rails to the frame.
•Install the upper portion of the bag be- tween the two struts on the upper portion of the frame and affix the bag to the front edge of the frame.
•Press on the snaps, one on each side. See Figure 11.
FIGURE 11
26. Attach bag to unit.
DT18 |
FIGURE 12
44
