Lubrication schedule, General | Husqvarna DT22 guide

LUBRICATION

Lubrication schedule

DT22

8011-281

General

Stop the engine and remove the ignition cable before attempting to lubricate the machine.

Unless otherwise specified, when lubricating with grease use Husqvarna’s Universal Grease no. 5310038-01 or Husqvarna’s Lubrication Grease UL 21 no. 5310060-74.

Wipe away excessive grease after lubrication.

It is important to avoid getting lubricant on the belt or the drive surfaces on the belt pulleys. Should this happen, attempt to clean them with spirits. If the belt continues to slip after cleaning, it must be replaced.

34

Image 34

Husqvarna DT22 manual Lubrication schedule, General

Contents

DT22 Table of Contents Introduction Symbols and Decals Decals and machine-bound instructions Location of decals Decal Seed application chart Translation of instructions Safety Instructions General use Safety Instructions Preparations Running Storage Movement/TransportChildren Fuel system Maintenance Presentation Presentation Main components and operating instruments Engine Throttle control Fuel valve StarterStarter handle Choke Oil dipstick Spark plugMuffler Oil drainage Fuel tank Fueling Depth lock Cutting unit Depth leverDepth knob Clutch Flail blade Setting blade heightBlade versatility Delta blade Operation Starting the engine Cutting the engine Starting Before you startFinishing Maintenance Maintenance schedule Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Fitting the wrong spark plug type can damage the engine Checking the drive belt Cutting unitReplacing the drive belt Wear/Rotation/Replacing flail blades When tipping the machine forward observe the Two minute rule Replacing worn flail blades Nuts Wear/Replacing spring tines Wear/Replacing delta bladesScrews Delta Blade Spring Tine Screw Cleaning and washing Two minute rule Lubrication schedule LubricationGeneral Engine oil Checking the engine’s oil level Depth lever Depth knob with depth lockBlades Handle Troubleshooting Symptom Cause Engine will not start Storage ServiceWinter storage Technical Data Specifications DT22 Assembly Instructions Assembly delivery service Bagger Assembly Assembly directions, catcher bag Attach the chute to the mainframe Extender Wire tie the cable to the handle. See Instructions for the catcher bag Correct height settingCollection conditions Seeder Assembly Do not use or start the engine until the seeder is in place Re-attach rubber flap rod with push nut to Seed Gate Cable Clamp Adjusting the seed hopper Instructions for the seeder Delivery service Service JournalAfter the first 20 hours Sound Test Vibraton LevelPage Page ´z+H3J¶6T¨ Page 114 01 2003W10