To start engine, Before stopping | Husqvarna EU8024STE, EU5524ST

To start engine

•Be sure fuel shut-off valve (F) is in the OPEN position.

Your snow thrower engine is equipped with both a 220 Volt A.C. electric starter and a recoil starter. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 220 Volt A.C. household current.

•Be sure your house is a 220 Volt A.C. three-wire grounded system. If you are uncertain, consult a licensed elec- trician.

WARNING: Do not use the electric starter if your house is not a 220 Volt A.C. three-wire grounded system. Serious personal injury or damage to your snow thrower could result.

COLD START - ELECTRIC STARTER (EU8024STE, EU1130STE)

1.Insert safety ignition key (D) into the ignition slot until it clicks. DO NOT turn the key. Keep the extra safety ignition key in a safe place.

2.Place throttle control (C) in “FAST” position.

3.Rotate choke control (E) to “FULL” position.

4.Connect the power cord to the engine (S).

5.Plug the other end of the power cord into a three-hole grounded 220 Volt A.C. receptacle.

6.Push the primer (T) three (3) times.

7.Push starter button (U) until engine starts.

IMPORTANT: Do not crank engine more than ﬁ ve continu- ous seconds between each time you try to start. Wait 5 to 10 seconds between each attempt.

8.When the engine starts, release the starter button and slowly move the choke control to the “OFF” position.

9.Disconnect the power cord from the receptacle ﬁ rst, then from the engine.

Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operating temperature.

WARM START - ELECTRIC STARTER (EU8024STE, EU1130STE)

Follow the steps above, keeping the choke control (E) in the “OFF” position.

COLD START - RECOIL STARTER

1.Insert safety ignition key (D) into the ignition slot until it clicks. DO NOT turn the key. Keep the extra safety ignition key in a safe place.

2.Place throttle control (C) in “FAST” position.

3.Rotate choke control (E) to “FULL” position.

4.Push the primer (T) four (4) times if the temperature is below –10°C (15°F), or two (2) times if temperature is between –10°C & 10°C (15°F & 50°F). If temperature is above 10°C (50°F), priming is not necessary.

NOTE: Over priming may cause ﬂooding, preventing the engine from starting. If you do ﬂ ood the engine, wait a few minutes before attempting to start and DO NOT push the primer.

5.Pull recoil starter (V) handle quickly. Do not allow starter rope to snap back.

6.When the engine starts, release the recoil starter handle and slowly move the choke control to the “OFF” posi- tion.

Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operating temperature.

WARM START - RECOIL STARTER

Follow the steps above, keeping the choke (E) in the “OFF” position. DO NOT push the primer (T).

Before stopping

Run the engine for a few minutes to help dry off any moisture on the engine.

To avoid possible freeze-up of the starter, proceed as follows: ELECTRIC STARTER (EU8024STE, EU1130STE)

1.Connect the power cord to the engine.

2.Plug the other end of the power cord into a three-hole grounded 220 Volt A.C. receptacle.

3.While the engine is running, push starter button and spin the starter for several seconds.

NOTE: The unusual sound made while starter is spinning will not harm the engine or starter.

4.Disconnect the power cord from the receptacle ﬁ rst, then from the engine.

RECOIL STARTER

1.While the engine is running, pull the recoil starter handle with rapid, full arm strokes three or four times.

NOTE: The unusual sound made while pulling the recoil starter handle will not harm the engine or starter.

If recoil starter has frozen

If the recoil starter has frozen and will not turn the engine, proceed as follows:

1.Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible.

2.Release the recoil starter handle and let it snap back against the starter.

If the engine still fails to start, repeat the above steps or use the electric starter (EU8024STE, EU1130STE).

Motor anlassen

•Stellen Sie sicher, dass das Benzin-Absperrventil (F) auf Position “OPEN” steht.

Der Motor Ihrer Schneefräse ist sowohl mit einem 220Volt A.C. Elektrostarter, als auch mit einem Anreißstarter ausgestattet. Der Elektrostarter ist mit einem dreidrahtigen Netzkabel und Netzstecker ausgestattet, und ist für den Betrieb bei einem Haushaltsstrom von 220 Volt A.C. geeignet.

•Stellen Sie sicher, dass Ihr Haus ein geerdetes 220 Volt A.C. Sicherheitssystem besitzt. Falls Sie sich dessen nicht sicher sind, befragen Sie einen Elektriker.

WARNUNG: Verwenden Sie den Elektrostarter nicht, falls Ihr Haus kein geerdetes 220 Volt A.C. Sicherheitssystem besitzt. Dies könnte ernsthafte Verletzungen oder Schäden an Ihrer Schneefräse zur Folge haben.

KALTSTART - ELEKTROSTARTER (EU8024STE, EU1130STE)

1.Stecken Sie den Sicherheitszündschlüssel (D) in das Zündschloss, bis es klickt. Schlüssel NICHT umdrehen. Bewahren Sie den Ersatzsicherheitszündschlüssel an einem sicheren Ort auf.

2.Stellen Sie den Gashebel (C) auf Position “FAST”.

3.Drehen Sie den Choke-Bedienungsknopf (E) auf Position “FULL”.

4.Schließen Sie das Netzkabel am Motor an (S).

5.Schließen Sie das andere Ende des Netzkabels an eine geerdete 220 Volt A.C. Schutzkontaktsteckdose an.

6.Sie die Einspritzvorrichtung (T) drei (3) mal.

7.Drücken Sie den Startknopf (U), bis der Motor anspringt.

WICHTIG: Kurbeln Sie den Motor nie länger als fünf Sekunden lang zwischen jedem Startversuch an. Warten Sie zwischen den Startversuchen 5 bis 10 Sekunden.

8.Sobald der Motor anspringt, lassen Sie den Startknopf los und bewegen Sie den Choke-Bedienungsknopf langsam in Richtung der “OFF” Position.

EU1130STE, EU5524ST, EU8024STE specifications

Husqvarna is renowned for its cutting-edge outdoor power equipment, and among its impressive offerings are the EU8024STE, EU5524ST, and EU1130STE models. Each of these snow throwers is designed to provide exceptional performance and lasting durability, making them ideal for tackling winter weather challenges.

The Husqvarna EU8024STE is a powerful snow thrower designed for heavy-duty use. Equipped with a robust 24-inch clearing width, it is capable of handling large amounts of snow efficiently. Its advanced electric start feature ensures that you can quickly get to work, even in the coldest conditions. This model features a high-performance engine that delivers optimal power and speed, making quick work of thick snow drifts. The dual-stage system enhances its ability to throw snow at impressive distances, and the adjustable chute allows for precise snow placement.

Next in line is the EU5524ST, which offers a balance between power and maneuverability. With a 24-inch clearing width, this model is ideal for residential use. It is powered by a dependable engine that ensures reliable performance without sacrificing ease of use. The EU5524ST features an efficient single-stage design, which makes it lighter and more agile while still being able to clear snow effectively. The user-friendly controls and the ergonomic handle contribute to a more comfortable experience during extended use.

Lastly, the Husqvarna EU1130STE stands out with its impressive clearing capabilities. With a larger 30-inch clearing width, this model is perfect for larger driveways and commercial applications. The dual-stage system, combined with its powerful engine, allows it to handle heavy snowfalls with ease. The EU1130STE also includes impressive features such as heated handles for added comfort during operation and LED headlights, ensuring visibility even in low-light conditions. The adjustable skid shoes also allow users to customize the height for different surfaces, making it versatile for use on various terrains.

Overall, the Husqvarna EU8024STE, EU5524ST, and EU1130STE snow throwers each bring their unique strengths to the table, catering to different user needs. Their innovative features and reliable performance ensure that snow removal becomes a hassle-free task, empowering users to conquer winter's challenges with confidence and efficiency. Whether for residential or commercial use, these models reflect Husqvarna's commitment to quality and innovation in outdoor power equipment.

Husqvarna EU8024STE, EU5524ST To start engine, Before stopping, If recoil starter has frozen

Models: EU1130STE EU5524ST EU8024STE