Assembly: saddle plate
A |
14 |
B |
13 |
Assembly: rachet mechanism
15 |
16 |
B |
(13)Thread the lifting line through the hole in the lower part of the saddle plate and make the knot shown (A).
Leave a 1 cm (3/8”) end after the knot.
(14)Press the steel sleeves into the holes in the plastic glides. Place the plastic glides (B) on each side of the lifting beam and fit the saddle plate over these. (4 x M6x40 collar bolts, 4 x M6 collar nuts)
(15)The ends of the ratchet cam axle are different. Insert the one that has the recess nearest the tip through the lower hole in the long leg.
(16)Thread the short end of the spring through the scale selector’s spring holder and slip both over the cam axle inside the long leg.
Now thread the axle through the first flange of the sadle plate. Thread the ratchet cam on in front of the opening in the sadle plate, placing an
Screw the cam axle handle locking screw (M6x10) in the other recess.
Use protective gloves for the following steps (B): Pull the long end of the spring aro- und to fasten it in the spring holder on the scale selector fitting.
13
