Husqvarna M7 manual Assembly chain-saw

Assembly: chain-saw

26

25

(25)Fit the Logosol extender nuts through the chain-saw plate using the front hole. (For some chain-saw models the rear hole has to be used to

ensure that the saw cover will not extend too far. However, this is relatively unusual.) Screw the chain-saw’s guide bar nuts onto the Logosol extender nuts under the plate and tighten.

(26)Fit the chain guard support on the two arms of the chain- saw plate so that the chain guard sits app. 4 cm (1 1/2”) from the tip of the guide bar. (2 x M6x40 bolts, 2 x M6 collar nuts)

(27)Push the assembled carriage onto the guide rail with the guide bar facing the log beds.

Check that the carriage moves easily on the guide

rail. If not, loosen the eight bolts holding the sliding rails, move the carriage back and forth and retighten the eight bolts. If this is insufficient, check the plastic slide rails for damage.

27

17