Husqvarna M7 manual Description, Assembly, Technical specifications, Tools needed

Description Assembly

-Because of the high quality and precision construction, none of the angles need setting. The only parts to adjust are the guide rail and the height of log bed, in all three bolts.

-All aluminium components are anodized, creating a wearing surface as tough as tempered steel. It has a low friction coefficient and is easy to keep free of pitch and chips.

-Adjustable legs make it easy to compensate for uneven sites.

-The M7 has a double rachet mechanism enabling a simple shift by hand between 1/4” (6.25 mm) and 1/8” (3.12 mm) increments.

-Clear scales show the height of the log bed. Extra measuring rods are available as accessories to show sawing height settings.

-The knee joint on the front leg has a non-slip surface that facilitates log handling. The joint also has a mounting hole for ramps, log tables and the like.

-The cross beam between the short legs is a significant stabilization factor.

-The Logosol M7 WoodWorkers Mill will not rust. Springs are stainless steel and all steel parts are thoroughly galvanized.

-No maintenance is needed. The crank axle runs through maintenance-free bronze bearings, the slide rails use low- friction plastic that has a working life of several years thanks to the superbly smooth surface anodization.

-The settings for sawing parallel to the grain of conical logs are quick and simple.

-All accessories for M7 sawmill fits the M7 WoodWorkers Mill as well.

Technical specifications

Length:	2.75 m (9 ft)
Width:	1.25 m (4 ft)

Width of log bed:0.5 m (1ft 8 in) Weightwithout saw:38.5 kg (85 lbs)

Max. rec. log diam.: 0.6 m (2 ft) Max. rec. log length (standard

design):	2.35 m (8 ft)
Max.logweight:	500 kg (1 100
lbs)

The M7 is designed for simple assembly and adjustment, mainly because there are fewer parts and assembly steps than were needed in earlier models. Most of the aluminium parts are anodized making it easier to force the bolts through the profile holes. Assemble the M7 on a surface that will not scratch the surface treatment.

Save time by reading the entire assembly instruction

before beginning to work. Then follow the instructions step by step.

Whenever this symbol appears, tighten bolt loosely

to allow some movement. When there is no symbol, tighten the bolts well.

Tools needed

(Tools are not supplied with delivery of the M7 WoodWorkers Mill.)

2 x 10 mm open end wrench

1 x 13 mm open end wrench

1 x 16 mm open end wrench

1 x 17 mm open end wrench Hexagon socket wrench/Allen key (metric)

1 x 4 mm open end wrench

1 x 8 mm open end wrench

1 x Try square

Assembly will be facilitated with a battery-driven drill or screwdriver with a 10 mm hexagon socket and a ratchet key with 10 and 13 mm hexagon sockets.

8