Replacing the light bulbs, Pro | Husqvarna Pro 18 specs

MAINTENANCE

Replacing the light bulbs, Pro 18

For information about the bulb type, see ”Technical

Data”.

1.Unscrew the two screws holding the cover on the power servo housing. Lift up the cover and turn it around the steering shaft.

2.Unscrew the two screws holding the lamp insert.

Lift out the lamp insert.

3.Disconnect the cables from the bulbs.

4.Lift out the bulbs from the insert.

5.Insert the new bulbs. Make sure you use your thumb to support the front.

6.Refit the cables, lamp insert and the cover on the power servo housing.

42 – English

Image 43

Husqvarna Pro 18 manual Replacing the light bulbs, Pro

Contents

Rider Pro 15 Rider Pro Contents Towing InstructionDear customer Driving and transport on public roads Good service Safety InstructionsSerial number Read the instructions Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Transport Presentation PresentationSpeed limiter Location of the controls Pro Cutting unit Presentation Chronometer Presentation PROThrottle control Choke lever Lift lever for cutting unit Lever for adjustment of the cutting height Seat Parking brakeFuelling Throttle control Lift lever for cutting unit Lights and power outlet Cutting tips DrivingRelease lever Before starting Driving PROStarting the engine Driving PRO Driving the machine Stopping the engine Before starting Driving PRO Driving the machine Stopping the engine Maintenance schedule MaintenanceYear Year 100 300 Transmission cover Removing of the machine hoodsEngine cover Pro Front cover Left-hand fender Pro Right-hand fender Pro Checking and adjustment of the steering wires Poorly adjusted brakes can result in reduced braking power Adjusting the parking brakeChecking and adjustment of the throttle wire Checking and adjusting the choke wire Replacement of the fuel filter Pro Check the transmission’s air intake Cleaning the pulse air filterChecking of the fuel pump’s air filter Muffler air intake Replacing the air filter Pro Maintenance Checking the engine’s cooling air intake Cleaning the engine and muffler Procedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Replacing the light bulbs, Pro Checking the tyre pressure Fuses Observe caution to avoid trapping your hand Fitting the cutting unit Removing the cutting unit Installing BioClip Cutting Height Checking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelism Belt change on Combi Maintenance Placing in service position Service position for the cutting unit Maintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, Combi Lubrication Lubrication chart Lubrication General Lubricating wires Pedal mechanism in frame tunnel Pro Triangular link and joints Chains in frame tunnelDriver’s seat Belt tensioner Throttle and choke wires, lever bearings Engine oil Changing the engine oil Gear lever Transmission oil level Parking brake wireTransmission Hydraulic oil filter, change Replacing the oil filter Problem Procedure Trouble Shooting Schedule Cover ServiceStorage Winter storage BL = Wiring Diagram PRO BR = Technical Data Side ejector Rear ejector Cutting unit BioClipCombi EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service ServicejournalWork done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´z+H.6¶6*¨ Page 2003W07 114 01