Pedal mechanism in frame tunnel Pro | Husqvarna Pro 18 guide

LUBRICATION

2.Pedal mechanism in frame tunnel Pro 15

Lubricate the pedal mechanism in the frame tunnel.

Remove the cover from the frame tunnel by undoing the screws, two on each side.

2. Pedal mechanism in frame tunnel

Pro 18

Lubricate the pedal mechanism in the frame tunnel.

Remove the cover from the frame tunnel by undoing the screws, two on each side.

Pump the pedals and lubricate the moving parts using an oil can.

Lubricate the wires connected to the brake and drive pedals using an oil can.

Lubricate as described under ”Chains in frame tunnel” before refitting the cover over the frame tunnel.

58 – English

Image 59

Husqvarna Pro 18 manual Pedal mechanism in frame tunnel Pro

Contents

Rider Pro 15 Rider Pro Contents Towing InstructionDear customer Driving and transport on public roads Serial number Safety InstructionsGood service Read the instructions Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Transport Speed limiter PresentationPresentation Location of the controls Pro Cutting unit Presentation Chronometer Presentation PROThrottle control Choke lever Lift lever for cutting unit Lever for adjustment of the cutting height Fuelling Parking brakeSeat Throttle control Lift lever for cutting unit Lights and power outlet Release lever DrivingCutting tips Starting the engine Driving PROBefore starting Driving PRO Driving the machine Stopping the engine Before starting Driving PRO Driving the machine Stopping the engine Year MaintenanceMaintenance schedule Year 100 300 Transmission cover Removing of the machine hoodsEngine cover Pro Front cover Left-hand fender Pro Right-hand fender Pro Checking and adjustment of the steering wires Poorly adjusted brakes can result in reduced braking power Adjusting the parking brakeChecking and adjustment of the throttle wire Checking and adjusting the choke wire Replacement of the fuel filter Pro Check the transmission’s air intake Cleaning the pulse air filterChecking of the fuel pump’s air filter Muffler air intake Replacing the air filter Pro Maintenance Checking the engine’s cooling air intake Cleaning the engine and muffler Fitting the wrong spark plug type can damage the engine Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Replacing the light bulbs, Pro Checking the tyre pressure Fuses Observe caution to avoid trapping your hand Fitting the cutting unit Removing the cutting unit Installing BioClip Cutting Height Checking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelism Belt change on Combi Maintenance Placing in service position Service position for the cutting unit Maintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, Combi Lubrication Lubrication chart Lubrication General Lubricating wires Pedal mechanism in frame tunnel Pro Driver’s seat Chains in frame tunnelTriangular link and joints Belt tensioner Throttle and choke wires, lever bearings Engine oil Changing the engine oil Gear lever Transmission Parking brake wireTransmission oil level Hydraulic oil filter, change Replacing the oil filter Problem Procedure Trouble Shooting Schedule Cover ServiceStorage Winter storage BL = Wiring Diagram PRO BR = Technical Data Combi Cutting unit BioClipSide ejector Rear ejector EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Work done ServicejournalPre-delivery service Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´z+H.6¶6*¨ Page 2003W07 114 01