MAINTENANCE
WARNING!
Observe caution to avoid trapping your hand.
8.Lift off the drive belt (1). Then pull out the pin
(2).
9. Pull the frame forwards and refit the pin.
10.Grasp the front edge of the cutting unit, pull out and raise into the service position.
If the cylindrical bolt, which is now holding the cutting unit is removed, the cutting unit can be lifted off.
Restoring from service position
To leave the service position, reverse the procedures set out in “Placing in the service position”. Make sure that the cutting unit’s “lug” (3) enters the loop correctly on the underside of the machine, see diagram.
1 |
2
52 – English
