14.Insert “L” end of throttle cable into the outside hole of the engine throttle control lever. Figure 7.
15.Attach the throttle cable to the engine using the double wire clamp removed in step nine. Figure 8.
16.Test throttle control by pulling back throttle handle on console. Throttle arm on engine should be pushed completely forward. Cable should not slip in clamp when doing this test.
17.Test proper wire length by pulling on the handle adjustment lever and raising and lowering the handle to maximum position without any pull on harness.
18.Reattach air cleaner to engine.
19.Unit is now ready to be removed from pallet.
1 |
2 |
FORWARD |
FIGURE 7
1.ENGINE THROTTLE CONTROL LEVER
2.THROTTLE CABLE
1 |
FIGURE 8
1. THROTTLE CABLE
17
