OPERATION
5.Tilt the machine on its wheels, lifting the cutting
wheel off the ground.
8011-202chg
6.Hold in the dead man’s grip bar and start the engine.
7.Allow the engine to warm up for two minutes at idle before grinding.
8. Set the throttle to FAST to ENGAGE clutch.
IMPORTANT INFORMATION
If the cutting wheel is too low, the machine may start to “climb” over the stump and become unstable.
9.Place the middle of the cutting wheel approximately one inch (2.5 cm) above and 3/4 to 1 1/2 inches
10.Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to side while lowering it about one inch (2.5 cm) after each pass until the front edge of the stump is gone.
29
