Manuals / Husqvarna / Lawn and Garden / Brush Cutter

Husqvarna SG13/968999353, SG13A, SG13 manual Engine, Throttle, Controls

Models: SG13/968999353 SG13A, SG13

1 50

Download 50 pages 16.43 Kb

Page 19

Image 19

CONTROLS

Engine

Exterior engine components and controls.

1.Throttle

2.Starter

3.Starter handle

4.Fuel valve

5.Choke control

6.Air filter

7.Spark plug

8.Muffler

9.Oil dipstick

10.Oil drainage

11.Oil level guard

12.Engine switch - disconnected use switch on handle bar

13.Fuel tank

14.Fuel filler cap

Throttle

The lever on the engine is normally not used. It is connected to the throttle on the handle. If the cable should bind or break, you can reduce the throttle with the lever on the engine as an emergency measure to slow the engine speed to an idle and stop the cutting wheel.

8011-126

12 11 9

8011-273chg

8011-034

1. THROTTLE LEVER

Page 19

Image 19

Husqvarna SG13/968999353, SG13A, SG13 manual Engine, Throttle, Controls

Contents

Operator’s Manual SG13A/CE/968999239SG13/968999353 MANUAL NO. 539109280 REV. 03 12/01/052005 Husqvarna All Rights Reserved Printed Beatrice, Nebraska Maintenance TABLE OF CONTENTS Stump Grinder SG13ASymbols and decals Safety instructionsInsure your machine Good serviceINTRODUCTION CongratulationsDecals and machine-bound instructions SYMBOLS AND DECALSIMPORTANT INFORMATION Decal Location of decalsTranslation of instructions Decal Important informationGeneral use SAFETY INSTRUCTIONSIMPORTANT INFORMATION Never leave the machine unsupervised with the engine running SAFETY INSTRUCTIONSIMPORTANT INFORMATION Use appropriate equipment PreparationsSAFETY INSTRUCTIONS Clear the work area before beginning workSAFETY INSTRUCTIONS OperatingSAFETY INSTRUCTIONS Movement/TransportStorage ChildrenSAFETY INSTRUCTIONS Fuel systemTurn off the engine and remove the spark plug cable MaintenanceSAFETY INSTRUCTIONS Personal equipment PROTECTIVE EQUIPMENTEquipment set-up SET-UPSET-UP 9. Remove air cleaner and double wire clamp from engine. FigureSET-UP 18. Reattach air cleaner to enginePresentation CONTROLSMain components and operating controls Throttle EngineCONTROLS Choke control StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickCentrifugal clutch Do not bind the bar to the handle It is there for your safetyFuel tank FuelingNEVER operate a machine with a defective brake On/Off Engine switch on the panelAdjustment bar for the handle BrakeFuel valve Engine switch on the engineOPERATION Starting the engineOPERATION Engine switch on the handleDead man’s grip bar Starter handleBrake Engine switchNormal shutdown Shutdown in emergency situationsOPERATION Before you start1. Place the cutting blade near the top front edge of the tree stump Using your stump grinderDISENGAGE 4. Set engine switch on handlebar to ON OPERATION5. Tilt the machine on its wheels, lifting the cutting OPERATIONIMPORTANT INFORMATION OPERATION 18. Shut off the machine when you are doneOperating on hills TransportThe machine is securely parked where it will not tip or begin rolling MAINTENANCEMaintenance schedule No service operations may be performed on the engine or unit unlessMAINTENANCE Cleaning the cyclone filterExercise care when reassembling to avoid damaging anything Make sure the air channel ends up in the proper positionIMPORTANT INFORMATION Replacing the air filterDO NOT wash the paper filter. DO NOT oil the paper filter MAINTENANCEMAINTENANCE Cleaning the sludge reservoirIdle adjustment Risk for carbon monoxide poisoning. Perform the adjustment outdoorsIMPORTANT INFORMATION Ignition systemFitting the wrong spark plug type can damage the engine MAINTENANCEMAINTENANCE Adjusting the drive beltMAINTENANCE Disassembling and reassembling the blade, pockets and teethL = Left mounting R = Right mounting Ensure that the tooth cutters are turned in the cutting directionMAINTENANCE Removing and refitting the wheelsMAINTENANCE Adjusting the brakeCleaning and washing Two minute rule8011-276chg LUBRICATIONIMPORTANT INFORMATION 1. Engine oilChecking the engine’s oil level LUBRICATION3. Throttle cable 2. Right wheelLUBRICATION Action TROUBLESHOOTINGSymptom CauseClutch is worn - replace shoes and springs, and/or clutch bearings ProblemPossible solutions TROUBLESHOOTINGSTORAGE ServiceWinter storage SG13A TECHNICAL DATASPECIFICATIONS ModelWIRING DIAGRAM Delivery service SERVICE JOURNALAction SERVICE JOURNALDate, stamp, signature