Technical Data, Model | Husqvarna SG13A, SG13, SG13/968999353

TECHNICAL DATA

SPECIFICATIONS:
Model	SG13A
Engine	Honda GX390
Cylinder volume	389 cm3 (23.7 cu in)
Power	13 hp (9.6 kW) at 3600 RPM
Torque	26.5 Nm at 2500 RPM
Idling speed	1250-1550 RPM
Spark plug	NK BPR6ES
	DENSO W20EPR-U
Fuel tank volume	6.5 liters/1.72 US Gal
Tires	4.10-6 (12” pneumatic)
Brake	Disk - Lever activated
Drive	Direct
Belt	Gates HiPower double V-belt BP54
Clutch	Noram centrifugal clutch
Cutting wheel	14” dia. x 3/8” thick disc (157.5 mm x 9.5 mm)
Cutters	8 cutters with tungsten carbide tips
	including pocket
Cutting depth	Approx 12” (30.48 cm)
Length	62” - 73” (157- 185 cm) depending
	on handle position
Width	27” (69 cm)
Height	24” - 43” (61 - 109 cm) depending
	on handle position
Weight	249 lb. (112.9 kg)

46

Image 46

Husqvarna SG13A, SG13, SG13/968999353 manual Technical Data, Model

Contents

Operator’s Manual Models Manual no REV 12/01/05 Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructions Decal Important information Location of decals Translation of instructionsDecal Safety Instructions General use Safety Instructions Preparations Operating Storage Movement/TransportChildren Fuel system Maintenance Protective Equipment Personal equipment SET-UP Equipment set-up Hair PIN Engine Throttle Control Lever Throttle Cable Presentation ControlsMain components and operating controls Throttle Engine12 11 Fuel valve StarterStarter handle Choke control Oil dipstick Spark plugMuffler Oil drainage Centrifugal clutch Fuel tankFueling Dead man’s grip bar Brake On/Off Engine switch on the panelAdjustment bar for the handle Never operate a machine with a defective brake Operation Starting the engine Dead man’s grip bar Engine switch on the handleStarter handle Shutdown in emergency situations Engine switchNormal shutdown Brake Before you start Using your stump grinder 8011-202chg Operating on hills Shut off the machine when you are doneTransport Maintenance Maintenance schedule Cleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Fitting the wrong spark plug type can damage the engine Adjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Cleaning and washing Adjusting the brakeTwo minute rule Lubrication Engine oil Checking the engine’s oil level Right wheel Throttle cable Troubleshooting Symptom Cause Action Problem Possible solutions Storage ServiceWinter storage Technical Data Model Wiring Diagram Service Journal Delivery service Service Journal