Lubrication | Husqvarna SG13A, SG13, SG13/968999353 manual

LUBRICATION

6								4	50	100	300
Yearly Months Weekly Daily								Hours	Hours	Hours	Hours

8011-276chg

40

Image 40

Husqvarna SG13A, SG13, SG13/968999353 manual Lubrication

Contents

Operator’s Manual Models Manual no REV 12/01/05 Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructions Decal Important information Location of decals Translation of instructionsDecal Safety Instructions General use Safety Instructions Preparations Operating Storage Movement/TransportChildren Fuel system Maintenance Protective Equipment Personal equipment SET-UP Equipment set-up Hair PIN Engine Throttle Control Lever Throttle Cable Presentation ControlsMain components and operating controls Throttle Engine12 11 Starter Starter handleFuel valve Choke control Spark plug MufflerOil dipstick Oil drainage Fuel tank FuelingCentrifugal clutch Dead man’s grip bar On/Off Engine switch on the panel Adjustment bar for the handleBrake Never operate a machine with a defective brake Operation Starting the engine Dead man’s grip bar Engine switch on the handleStarter handle Engine switch Normal shutdownShutdown in emergency situations Brake Before you start Using your stump grinder 8011-202chg Operating on hills Shut off the machine when you are doneTransport Maintenance Maintenance schedule Cleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Fitting the wrong spark plug type can damage the engine Adjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Cleaning and washing Adjusting the brakeTwo minute rule Lubrication Engine oil Checking the engine’s oil level Right wheel Throttle cable Troubleshooting Symptom Cause Action Problem Possible solutions Storage ServiceWinter storage Technical Data Model Wiring Diagram Service Journal Delivery service Service Journal