SET-UP
1.Remove crate top and sides.
2.Remove upper handle bar assembly and lay aside.
3.Open bag containing loose hardware.
4.Using four (4) screws, flat washers and nuts attach the upper handle bar assembly to lower handle bar assembly.
NOTE: Handle fit is tight. When aligning holes use a tapered type pilot to help align holes (i.e. punch or phillips style screw driver).
5.Attach the position adjusting rod to bracket on the upper handle bar assembly with the washers and cotter pins placed above the rod bracket. Attach the lower adjustment bar to the unit and secure with cotter pin.
6.Assemble the compression spring, two (2) flat washers and yoke to brake rod assembly.
7.Screw yoke onto the rod assembly until rod is even or through threaded portion of yoke about ¼" (6.35 mm).
UPPER HANDLE BAR |
|
WASHERS | COTTER PINS |
ADJUSTING ROD |
|
LOWER |
|
HANDLE BAR |
|
WASHERS |
|
NUT |
|
| SPRING |
YOKE |
|
8.Attach brake rod assembly to brake handle on the upper handle bar assembly.
| BRAKE |
BRAKE ROD ASSEMBLY | HANDLE |
|
