LUBRICATION
Checking Engine Oil Level
Make sure that the machine is parked on flat ground with the engine stopped when checking the oil level.
1.Unscrew the dipstick and wipe it using paper towel or a
2.Replace the dipstick without screwing it in. Remove and check the level on the dipstick.
3.Fill oil as necessary to the lip of the dipstick hole. Oil type, see above.
4.Check that the rubber gasket is in position and screw the dipstick back into place. DO NOT tighten it askew or too hard or you may damage the threads.
Right wheel
Lubricate using a grease gun until the grease squeezes out one nipple.
Use good quality MP grease. Grease from
Throttle cable
Peel back the rubber covers at both of the cable mountings. Grease both ends of the throttle cable and move the controls to end stop positions when lubricating. Refit the rubber covers on the cable after lubrication. Cables with sheaths will bind if they are not lubricated regularly. Binding in a cable may cause malfunction.
If the cable binds, remove the cable and hang it vertically. Lubricate it with thin engine oil until the oil begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that it seals against the casing and allow the cable to hang vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.
