SET-UP
7.Set the brake rod assembly into the brake bracket. The brake rod assembly needs to be adjusted before connecting the yoke to the brake. Turning the yoke clockwise shortens the rod, tightening the grip on the brake disc by the brake pads. Counterclockwise loosens the clamping force.
8.After adjustment, attach the yoke to the brake’s top mounting hole using the clevis pin and cotter pin.
9.Turn the adjustment nut against the spring and washer until the spring set snugly against the brake bracket and has a small amount of tension.
With proper brake adjustment, the wheel will slide, but not turn, when the handle is over center.
To engage brake, pull back on the handle until brake rod assembly goes “over center” and locks the brake ON. Test for proper tension and grip.
ADJUSTMENT NUT | BRAKE BRACKET |
| |
CLEVIS PIN |
|
HAIR PIN |
|
10.Remove air cleaner and double wire clamp from engine.
CLAMP |
11.Route the wire harness from engine and the throttle cable through guide and handle crossmember.
12.Connect upper and lower wire harness together, yellow to
THREAD WIRE HARNESS AND THROTTLE CABLE
GUIDE
16 - HUSQVARNA
