CONTROLS
Operator Presence (OP) Grip Bar
The bar must be held against the handle for the engine to run. If the grip is released, the ignition system short- circuits and the engine stops.
WARNING!
Do not
Throttle
The lever controls engine speed.
With the lever down, the engine runs at idle and functions as start position.
When the engine speed increases, the centrifugal clutch drive automatically engages the cutting wheel.
Control Panel On/Off Engine Switch
The ON/OFF engine switch can be used to stop the engine. The illustration shows the toggle switch in the OFF position (short circuited electrical system).
A second switch with the same function is activated by the OP grip bar.
To start the engine, the control panel switch must be set to the ON position and the OP grip bar must be held in.
ON |
OFF |
24 - HUSQVARNA
