Husqvarna SG13B manual Set the handle throttle to Fast to engage clutch

operation

5.Tilt the machine on its wheels, lifting the cutting wheel off the ground.

6.Hold in the OP grip bar and start the engine.

7. Allow the engine to warm up for two minutes at idle before grinding.

8060-200

8. Set the handle throttle to FAST to engage clutch.

8060-027

9. Place the middle of the cutting wheel approximately 1" (2.5 cm) above and ¾" to 1½" (2-4 cm) into the stump.

10.Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to

side while lowering it about 1" (2.5 cm) after each pass until the front edge of the stump is gone.

IMPORTANT INFORMATION

If the cutting wheel is too low, the machine may start to “climb” over the stump and become unstable.

8011-203a

30 - HUSQVARNA