Husqvarna SG13B manual Cutting Wheel

MAINTENANCE

5.Loosen the locking nuts (B) on the two tension bolts.

6.Turn the two tension bolts (C) counter-clockwise to loosen the belt or clockwise to tighten it.

IMPORTANT INFORMATION

If pulley on cutter head shaft must be moved, the set screws MUST be fully removed, fresh “Loctite 242” put on threads and re-torqued to 100 - 110 in./lbs. (17513 / 19264 N•m).

7.Check that the pulleys are aligned using a straight edge along the inside face of the clutch and pulley. Pulleys must be inline. Maximum gap or mis- alignment is 1/16" (.062) or 15.7 mm. Adjust using the tension bolts as necessary. Check belt tension again.

8.Tighten all screws and nuts when the adjustment is complete. Be certain cover plate is not rubbing against cutter wheel shaft.

9.Refit the belt guard.

AC B

8011-228

CHECK CLUTCH &

PULLEY ALIGN

USING INSIDE FACE

8011-229

Cutting Wheel

WARNING!

The cutters can come loose from the cutting wheel if the bolts are not sufficiently tight. Comply with the recommended torque settings.

Tighten the screws 30 ft/lbs. (133 Nm).

TOOTH CUTTER

(CARBIDE FACE)

40 - HUSQVARNA