LUBRICATION
Lubricating the Cables
If possible, lubricate both ends of the cables and move the controls to end stop positions when lubricating. Refit the rubber covers on the cables after lubrication. Cables with sheaths will bind if they are not lubricated regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it vertically. Lubricate it with thin engine oil until the oil begins to escape from the bottom.
Hint!: Fill a small plastic bag with oil and tape it so that it seals against the sheath and allow the cable to hang vertically from the bag overnight. If you do not succeed in lubricating the cable, it must be replaced.
Lubricating in Accordance with the Lubrication Schedule
1. Front Wheel Mount
Lubricate with a grease gun, one zerk for each wheel mount, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from
2. Front Wheel Bearings
Lubricate with a grease gun, one zerk for each set of wheel bearings, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from
Lubricating the front wheels
3.Throttle and Choke Cables, Lever Bearings
Lubricate the cable end at the carburetor with the oil can. Move the control to the end points and lubricate again.
Throttle and choke cables by the carburetor
