MAINTENANCE
Checking the Parking Brake
Visually check that no damage is found on the thumb latches. Perform a test drive and check that there is a sufficent braking action.
To adjust the brake, contact the service workshop if you are uncertain. Set the thumb latches in the neutral locked position. Tighten the wing nut. Check if the machine is braked, if not tighten the wing nut again.
Checking the V-belts
Deck belt
Check every 100 hours of operation. Check for severe cracking and large nicks.
NOTE: The belt will show some small cracks in normal operation.
To replace belt lower the deck to its lowest position. Remove the plate and belt shields.
Use a ratchet with a 9/16” socket on the spring idler bolt to relieve the tension on the belt. Slide the belt off the pulley and remove the belt.
Reverse the proceedure for installation. See the decal on the top of deck for belt routing information.
After installation is complete check the belt for twists.
The thumb latches in locked position
Slackening the belt tensioner
