Husqvarna WG3213P/968999114, WG3613P/968999116, WG4815P/968999278 manual Mowing Tips

OPERATION

Mowing Tips

•Observe and mark rocks and other fixed objects in order to avoid collisions.

•The cutting deck should be properly leveled for best mowing performance. The blades should be parallel to the ground or slightly tipped down in the front.

•Only use sharp blades.

•Check tire pressure. Different pressure can cause uneven mowing result.

•The left hand side of the deck should be used for trimming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the mower.

This will result in more even distribution of clippings and a more uniform cut. To avoid clippings spraying on roads etc, mow the first two patterns in opposite direction.

•Begin with a high cutting height and reduce it until the desired mowing result is attained.

The average lawn should be cut to 2 1/2" (64 mm) during the cool season and to over 3" (76 mm) during the hot months. For healthier and better looking lawns, mow often after moderate growth.

For best cutting performance, grass over 6" (15 cm) in height should be mowed twice. Make the first cut relatively high; the second to the desired height.

•The mowing result will be best with a high engine speed (the blades rotate rapidly) and low speed (the machine moves slowly). If the grass is not too long and dense, the driving speed can be increased without noticeably depreciating the mowing result.

•The finest lawns are obtained by mowing often. The mowing becomes more even and the grass clippings more evenly distributed over the mown area. The total time taken is not increased as a higher driving speed can be used without poorer mowing results.

WARNING!

Clear the lawn of stones and other objects that can be thrown out by the blades.

8011-409

Mowing patterns

English-27